Installation guide

Synapse Installation Guide Back to Contents
Installation 41
To install the Deskset on a wall:
1. Plug the Ethernet cable into the port on the back of the Deskset. (See “To connect
the Cat.-5 LAN cable to the Deskset:” on page 39.)
2. Plug the power adapter into the jack on the back of the Deskset. Skip this step if
using POE. (See “To connect power:” on page 40.)
3. Place the Deskset base over the mounting plate above the mounting studs as shown
in .
4. Slide the Deskset base down as shown in .
5. Plug the Ethernet cable into the wall jack.
6. Plug the power adapter into a power outlet not controlled by a wall switch. Skip this
step if using PoE.
7. Make sure the Handset tab is in Wall position, as described in “To rotate the Handset
tab for wall and Deskset Option 2 installation:” on page 38.
8. Connect the corded handset to the handset jack on the left side of the Deskset.
Wall-Mount
Screws