Installation guide

Synapse Installation Guide Back to Contents
Installation 50
Battery Charging
Charge the Handset battery for at least 16 hours before use. When fully charged, the
Handset battery provides approximately five hours of talk time or three days of standby
time.
To charge the Handset battery:
Place the Handset in the charger, as shown.
 The CHARGE light is on when the Handset is charging.
 If the Handset has not yet been registered, the Register screen appears within
15 seconds.
To register the Handset, follow the on-screen instructions or see the
“Handset Registration” section in the AT&T SB67040 Cordless Accessory
Handset Quick Start Guide that was packaged with the Handset and
available at
www.telephones.att.com/synapseguides.
CHARGE
light
12:00a Jan. 0012:00a Jan. 00
To register Handset:
1. Go to your
Deskset.
2. Press MENU.
3. Select User
REGISTER 1/3
Place the Handset in the charger when not in use.