Installation guide

Synapse Installation Guide Back to Contents
Installation 53
Battery Charging
After installing the battery, charge the Headset by placing it in the Headset charger as
shown below. Before registration, the Headset ON/OFF
light flashes twice every five
seconds whether the Headset is charging or not. After registration, the Headset ON/OFF
light is on when the Headset is charging.
To charge the battery:
1. Insert the Headset into the charger as shown.
2. Push the Headset downward until the Headset ON/OFF light turns on.
If the Headset has not yet been registered, the ON/ OFF light flashes blue and orange.
To register the Headset, use the process described in “Registering an Optional
Cordless Headset” in the AT&T SB67030/031 Deskset and Accessories User’s
Guide and in the SB67020/SB67025 Deskset User’s Guide at
www.telephones.att.com/synapseguides.
ON/OFF
Light
Place the Headset in the charger when not in use.