Installation guide

Synapse Installation Guide Back to Contents
Getting Started 68
ATA Front Panel Interface
You can access basic information and perform some configuration tasks using the ATA
front panel. These tasks are easier to do using the WebUI. See “WebUI Overview” on
page 76.
The ATA displays the Idle screen after powering up. Access the ATA Main menu to
perform the system operation functions.
Figure 39. ATA Idle Screen
To access the ATA Main menu from the Idle screen, as shown in Figure 39, press the
key. The menu provides the following functions:
 Device Information
 Network Status
 Configuration
Figure 40. ATA Menu Screens
Press the key to highlight an entry, then press to see information
about your ATA or your network, as shown in Figure 40. Select Configuration to view
or modify some ATA settings. Here is the information you can see in Device Information
and Network Status:
Device Information
 Model #
 Serial #
 Boot Version
 Software Version
 Firmware Version
Network Status
 IP Address
 Subnet Mask
 Default Gateway
 DNS Server X
 MAC Address
 Network Port
 Local Address
30)HE
6\QFKURQL]HG
,3
$7$
Dev ic e Inf ormation
Netw ork Status
Configuration