Installation guide
Synapse Installation Guide Back to Contents
System Configuration 76
WebUI Overview
If two Synapse devices are connected to the LAN, and as long as one Synapse device is
currently on the same subnet as a PC, you can use the WebUI to administer the system.
Only one person should log in as system administrator at a time to prevent accidentally
overwriting and losing intended changes.
Any PCs used for configuring the WebUI must be connected to the same IP subnet as
the devices they will manage, or to other subnets that the PCs can communicate with.
Confirm either that all devices are connected to the same router, or that the first three
octets of the IP address are the same for all system devices. The Gateway displays its IP
address in the Idle mode as shown in Figure 42. To determine the Deskset IP address,
press MENU, then 4 on the Deskset dial pad to display the Deskset Information screen
shown in Figure 42.
Figure 42. Device IP Addresses
WebUI information for Deskset users is contained in the “Web Interface” chapter
of the SB67020/025 Deskset User's Guide and the SB67030/031 Deskset and
Accessories User's Guide at
www.telephones.att.com/synapseguides.
30)(%
3671/LQHV
6\QFKURQL]HG
,3
'HVNVHW,QIRUPDWLRQ
0RGHO1R6%
6WDWXV6\QFKURQL]HG
,3$GGUHVV
Deskset Information
Quick
Dial
Model No: SB67031
Status: Synchronized*
IP Address: 192.168.0.103
MAC Address: 00:11:A0:11:EA:4D
Serial No: GG20013043
Boot Ver: 2.7.1
P Firmware Ver: 3.0.0
Exit
Use or to scroll. Press Exit when
done.
Gateway Idle Screen
020/025 Deskset
Information Screen
030/031 Deskset
Information Screen
In most cases there are multiple settings on one page. Changing a setting does
not instantly apply the new value. Click on the WebUI to save all
changes on that page.
Changes made on the WebUI are transmitted to all connected devices when
applied. If changes are being made at the Deskset and WebUI simultaneously, a
first-come-first-served policy on resource allocation applies. System
configuration changes are transmitted globally when you press on the
Deskset or click on the WebUI.