Installation guide

Synapse Installation Guide Back to Contents

Troubleshooting 97

Common Troubleshooting Procedures

Follow these procedures to resolve common issues.

Resetting Devices

You may need to manually restart a device or return a device to factory defaults (see

“Appendix C: Default Settings” on page 147). To reset a device, press the RESET button

shown in Figure 46 on page 98 and Figure 47 on page 98 by inserting a pen or paper

clip into the hole and applying pressure to the button. The T1 Gateway, SIP Gateway, and

ATA (not shown) have a RESET button in the same front-panel location as the PSTN

Gateway. Although Figure 47 on page 98 shows the SB67030/031 Deskset, the

SB67020/025 Deskset RESET button is in the same location. The SB67080 Expansion

Module RESET button is located on the back of the unit, below the network port.

To restart the device without losing any custom settings, press the RESET button for less

than five seconds. You can get the same result by disconnecting and reconnecting power

to the device. You can restart the device if the device does not respond or fails to

synchronize with the system.

To completely reset the device to factory defaults, unplug the LAN cable and press the

RESET button for more than five seconds. You might do this if the device is not

synchronized or you want to reset the IP address settings to Auto (DHCP). Any static IP

configurations are lost.

When resetting a Deskset to factory defaults, the system configuration (the user settings

and Personal directory) and Voicemail messages, Call Log, and the Redial list are all

deleted. You can use this complete reset when assigning Desksets to new users. If you

do not disconnect the LAN cable before pressing the RESET button, the extension

number is retained, and Group Mailbox messages associated with the Deskset are

recovered from the ATA. During the reset, any PC connected to the Deskset PC port

momentarily loses network connectivity.

If there is one Gateway in the system, but there are still Desksets connected, then only

the voice prompts and hold messages are deleted; the rest of the Auto Attendant settings

are maintained on the Desksets. If there is another Gateway, the other Gateway

maintains all system configuration settings.

To reset the entire system to factory defaults and completely clear the system

of all settings (Auto Attendant, Ring Groups, hold message, and System

Directory) and Voicemail messages, unplug the LAN cables from all devices and

press the RESET button for more than five seconds on each device. Then

reconnect all devices to the LAN.

If you have already set up the system, back up the Deskset and system settings

before resetting the device to factory defaults.

For more information, see the Synapse Administrator’s Guide at