User`s guide

Deskset Settings 180
Synapse SB67030/031 Deskset & Accessories User’s Guide Back to Contents
To turn Call Forward All on or off, press when the Deskset is idle. When
activated, appears in the upper right corner of the display. Call Forward
All overrides the Call Forward–No Answer setting set by your system
administrator.
You can set the Call Forward All destination in the User Settings menu or using
the WebUI. See “Basic Settings” on page 206.
 Call Forward–No Answer can only be set by the system administrator. This
setting determines the delay of, and the destination for, unanswered calls for
each extension. The default destination is Voicemail.
Call Appearance mode only — The Call Forward–No Answer setting does not
apply to Ring Group calls or to incoming calls at extensions that are part of a
Call Queue. See “Answering Calls in the Call Queue” on page 65.
To set the Call Forward destination:
1. Press MENU, then 2, and then 2. The Call Forward All menu appears.
2. Press
 or  to select one of the following targets:
 Mailbox. Then press  to move to the to Mailbox: field and select your
personal mailbox or a Group Mailbox (if enabled).
 Ext. Then press  to move to the to Ext: field and enter a valid extension
number.
 Phone #. Then press  to move to the to Phone #: field and enter a valid
phone number. Enter a preceding 9 or whatever digit, if any, that must be dialed
for outside calls.
3. To confirm the change, press . The User Settings menu appears. An error
message appears if:
 you entered an invalid extension number
 your system administrator has disabled call forwarding/transferring to an outside
line
 you enter a restricted number.
CallFwd
FWD ON
Save