User`s guide

Overview 42
Synapse SB67030/031 Deskset & Accessories User’s Guide Back to Contents
Cordless Headset Operation
Table 14 TL7600 Cordless Headset Operation
Function Operation
Ringtone
silencing
Press MUTE/FLASH to temporarily silence the ringtone in the Headset earpiece.
This silences the ringtone without disconnecting the call. The next incoming call
rings normally at the preset volume.
Volume control
While on a call, use the VOLUME + / – keys on the side of the Headset to adjust the
listening volume.
Mute Press MUTE/FLASH to turn the Headset microphone on or off. When mute is on,
there is a short beep every 10 or 15 seconds until mute is turned off. The
SB67030/031 Deskset does not support the flash feature.
Answering a call Press ON/
OFF on the Headset.
Ending a call Press
ON/OFF on the Headset.
Auto off A call ends automatically when you put the Headset in the charger.
Alert tones You hear three short beeps when:
 VOLUME +/– keys are pressed when the volume is already at its highest or
lowest setting.
 The Headset is not registered and the Headset ON/OFF button was pressed.
 The Headset has gone out of range from the Deskset during a call.
Low battery
warning
You hear 1 short beep every 20 seconds when the battery is low.
Key beep You hear 1 short beep when pressing the Headset ON/OFF key to start or end a
call.
ON/OFF light
status
On — Headset is registered to the Deskset and is charging in the Headset
charger.
Flashes quickly — There is an incoming call.
Flashes three times followed by a pause — The battery level is very low. The
cycle repeats three more times before the headset shuts down.
Flashes twice in orange and blue every five seconds — The Headset is not
registered.
Flashes every 20 seconds — The battery is low and needs to be charged in the
Headset charger.
Flashes every three seconds — The Headset is in use.
i
The MUTE button on the Deskset does not mute the Cordless Headset.