User Manual

ManualsBrandsAT&T ManualsOffice ElectronicsAT&T SynJ SB67128 Repeater for the AT&T SynJ SB67138 & SB67158 Small Business Phone System

SynJ SB67128 DECT 6.0 Repeater

This manual contains information about

this product’s installation and operation.

Please also read Part 1 - Important

product information.

For customer service or product information,

visit our website at www.telephones.att.com

or call 1 (888) 915-2007. In Canada, dial 1 (866) 288-4268.

User’s manual

Part 2

AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to

Advanced American Telephones, San Antonio, TX 78219.

San Antonio, TX 78219.

SynJ® is a trademark of Advanced American Telephones.

® is a trademark of Advanced American Telephones.

is a trademark of Advanced American Telephones.

Printed in China. Issue 10.0 AT&T 12/14.

www.telephones.att.com

Summary of content (12 pages)

PAGE 1
For customer service or product information, visit our website at www.telephones.att.com or call 1 (888) 915-2007. In Canada, dial 1 (866) 288-4268. This manual contains information about this product’s installation and operation. Please also read Part 1 - Important product information. SynJ SB67128 DECT 6.0 Repeater User’s manual Part 2 www.telephones.att.com ©2009-2014 Advanced American Telephones. All Rights Reserved.
PAGE 2
Before you install Parts list • • • • • SynJ��®� �� SB67128 DECT �� 6.0 repeater Power adapter Part 1 Important product information Part 2 User’s manual Package of screws Use only the power adapter supplied with this product. To obtain a replacement, visit our website at www.telephones.att.com or call 1 (888) 915-2007. In Canada, dial 1 (866) 288-4268.
PAGE 3
About the repeater You can use a repeater to extend the operating range for the SynJ SB67118/SB67138/SB67158 DECT 6.0 4-line corded/cordless telephone system to cover areas where the signal is very weak or not available. The repeater extends the range in all directions, even going around certain barriers. The telephone base, cordless handsets and repeaters are linked through wireless connections.
PAGE 4
Registration You should register your repeaters to the telephone base before choosing locations for them in the building. NOTE: You can register a repeater to a SynJ SB67118/SB67138/SB67158 telephone base without deregistering it from the previous telephone base. New registrations overwrite any previous repeater registrations. Repeater registration 1. Plug in the repeater to AC power. The STATUS indicator light on the repeater flashes slowly. 2.
PAGE 5
Registration STATUS indicator light Slow flash The repeater is powered on and in idle mode waiting to be registered again. -ORThe registered repeater is not connected to the telephone base. -ORYour telephone base has no power. Quick flash The repeater is registering to the telephone base. On The repeater is successfully registered and in a normal operation mode. Off The repeater has no power.
PAGE 6
Installation After you have plugged in your repeaters in the locations you think the best, place a call from a cordless handset (SynJ SB67108). While talking, move around the building to test the reception. You may want to adjust the position of repeaters to receive the best reception. Plug the small end of the power adapter into the power jack on the front of the repeater and route the cord through the slot on the bottom of the repeater.
PAGE 7
Installation You can place the repeater on a tabletop. You can install your repeater on a wall or other object with the provided screws. Please use the recommended placement and installation tips as follows: • The antennas need to be in a high location (not on the floor or under a desk) for reception. • Maintain a minimum of 30 feet distance between each repeater. • See page 2 for additional placement information.
PAGE 8
Installation If you want to install your repeater on a wall or other object, use the provided screws. Professional assistance may be required to install screws on the wall. Then, plug the large end of the power adapter into a nearby electrical wall outlet and raise the antennas. ^ ^ Screw holes Screw spacing=2.
PAGE 9
Troubleshooting If you have difficulty operating this repeater, try the following suggestions. To contact Customer Service, purchase accessories or obtain replacement parts, visit our website at www.telephones.att.com or call 1 (888) 915-2007. In Canada, dial 1 (866) 288-4268. Please retain your receipt as your proof of purchase. My repeater doesn’t work at all. • Make sure the power cord is securely plugged in. • Make sure the STATUS indicator light is on.
PAGE 10
Troubleshooting My repeater cannot register to my telephone base. • First try all the suggestions on the previous page. • Make sure your telephone base is a SynJ SB67118/SB67138/ SB67158 DECT 6.0 4-line corded/cordless telephone system. • Carefully follow the registration instructions on page 3 of this user’s manual. • Make sure your telephone base is within 980 feet of the repeater. If registration does not work, place the repeater next to the base and try registering again.
PAGE 11
General product care To keep the repeater working and looking good, follow these guidelines: • Avoid putting it near appliances and devices that generate electrical noise (motors, fluorescent lights, etc.) • DO NOT expose it to direct sunlight or moisture. • Avoid dropping the repeater. • Clean with a soft cloth. • Never use a strong cleaning agent or abrasive powder because this will damage the finish. • Retain the original packaging in case it is necessary to ship it at a later date.
PAGE 12
Technical specifications RF frequency band 1921.536MHz - 1928.448MHz Channels 5 Operating temperature 32°F - 122°F 0°C - 50°C Repeater voltage (AC voltage, 60Hz) 110Vrms - 120Vrms Repeater voltage (AC adapter output) 6VDC @600mA SynJ SB67128 repeater disclaimer range 980 feet Open range test was performed by Wyle Laboratories, an independent commercial test facility. “Up to 980 feet” repeater range refers to the maximum open field range. Actual range may vary depending on intervening obstacles.