User`s manual

Page Page 12 13
The main functions of this system can be operated by the controls on the top panel of the
docking station, or by the buttons on the remote control. If a specific function can only be
operated by the remote control, this will be clearly indicated in this manual.
When operating this system with the remote control, make sure that the Infrared
transmitter on the front of the remote control is pointed at the remote sensor on the front
panel of the docking station.
Press the button and gently dock your iPhone/iPod into the 30 pin connector on the
front of the docking station. Do not force. If you have not already downloaded the free app
from the iTunes App Store, you will see the following message on your iPhone/iPod Touch
display: “This accessory requires an application that you do not have installed. Would you
like to install it from the app store?” The purpose of this message is to advise you that you
must download the app to enjoy the enhanced features of SongStream. (See page 15 for
more details.) You will have full access to all the standard features of SongStream without
installing the app.
Note: The 4G iPod, iPod Classic and 5G iPod are not supported for charging with SongStream.
Operational Instructions
General
Docking Your iPhone/iPod
Adapter Instructions
Operational Instructions
SongStream comes with 6 removable dock adapters. Using the correct adapter ensures
the proper fit for your iPhone/iPod and helps to reduce the stress on the connector when
operating the iPhone/iPod.
When connecting your iPhone/iPod to this dock, please ensure that the correct
adapter plate is used. Failure to do so may result in damage to the iPhone/iPod
and the dock.
Power failure: In the event of power loss during the iPod/iPhone playback,
please turn on the power of the docking station and press play on your music
device, once the power is up.
1. Refer to the compatibility table in this manual and select the correct dock adapter for
your iPhone/iPod.
2. Place the proper adapter into the dock and press it into position.
The adapter will only go in one way. The 30-Pin connector should fit through the
opening in the bottom of the adapter.
3. Carefully align and then gently
insert the iPhone/iPod into the
dock.
4. To remove/replace a dock
adapter, first remove the
iPhone/iPod, then grip the
adapter and gently pull upwards.
Note: Please note that older 3rd,
2nd and 1st generation iPods are
incompatible with SongStream.
important! important!
Installing a dock adapter
To remove an adapter from the
dock, press it’s inside rear surface
and gently pull it upward.