User`s guide

Using a TI

700 Printer

Printing Call

Handling Reports

Resetting the Counters

There are two sets of switch settings to check on TI 700 printers. The four pencil

switches under the paper compartment cover must be set as follows (On =

Closed; Off = Open):

● Switch 1: OFF

● Switch 2: ON

● Switch 3: OFF

● Switch 4: ON

The three rocker switches at the upper right of the keyboard must be set as

follows:

● UPPER CASE: OFF (Left side of the switch pressed down)

● ON LINE: ON (Right side of the switch pressed down)

● LOCAL COPY: OFF (Left side of the switch pressed down)

Once the cable is configured and the printer is connected, perform the following

steps to print a report:

NOTE:

If any of the report counters exceed 65,535 total, the counter is

reset to 0.

1. Select an outside line and dial a telephone number that is answered by the

SPIRIT Attendant.

2. Wait for an answer.

3. Dial ✳ followed immediately by the authorized caller code and #.

4. Dial ✳ 2909 and the following appropriate choice:

1 = print route programming

2 = print traffic analysis report

= print business schedule

4 = print announcement time allocations

5. Dial #.

A single beep will confirm the report has completed.

6. Once the report is complete, exit authorized caller mode by dialing ✳ #.

7. To disconnect, dial #.

To reset the call handling traffic statistics to 0, perform the following steps:

1. Select an outside line and dial a telephone number that is answered by the

SPIRIT Attendant.

2. Wait for an answer.

3. Dial ✳ followed immediately by the authorized caller code and #.

4. Dial

✳

29101#.

3-6

Testing and Troubleshooting