User`s guide

5. Exit authorized caller mode by dialing ✳ #.
6. To disconnect, dial #.
Printing Call
To print the current settings of call processing options, perform the following
Processing Reports
steps:
1. Select an outside line and dial a telephone number that is answered by the
SPIRIT Attendant.
2. Wait for an answer.
3. Dial ✳ followed immediately by the authorized caller code and #.
4. Dial ✳ 29 followed by the appropriate selection:
01 =
Day Answer Delay
02 =
Night Answer Delay
03 =
Dialing Delay
5. Dial #.
A single beep will confirm the report has completed.
6. Once the report is completed, exit authorized caller mode by dialing ✳ #.
7. To disconnect, dial #.
Lost Authorized
If the default authorized caller code (789) is changed and the new code is lost or
Caller Code
forgotten, the default code can be restored. However, this procedure also restores
all the SPIRIT Attendant default settings so that any changed programmed setting
must be reentered and all announcements must be rerecorded.
To restore the default authorized caller code:
1.
2.
3.
4.
5.
6.
7.
On the back of the SPIRIT Attendant, set switches 1 and 2 to off (up).
Unplug the SPIRIT Attendant from its power source.
With switches 1 and 2 still off (up), plug the SPIRIT Attendant back into its
power source.
Reset switches 1 and 2 to on (down).
Dial the default authorized caller code ( ✳ 789#).
Dial
✳ 990047 # (the SPIRIT macro code).
Use the SPIRIT Attendant Planning Configurator Form to reprogram the
settings and rerecord the announcements.
Testing and Troubleshooting 3-7