User`s manual

Getting started

Adding and registering a headset

Option 1: To register a headset to your TL7610 headset base

Make sure the battery is properly installed in the

headset (see page 8). The ON/OFF light flashes

twice every five seconds to indicate the headset

is not registered.

Place the headset in the headset base or

charger and allow it to charge for at least five

minutes before the registration.

Remove the headset from the headset base

or charger.

Press and hold the PAIR button until the

MUTE light on the headset base turns on

(about four seconds) and release the button.

Return the headset to the headset base

for registration.

It may take about 30 seconds to complete the registration. The

MUTE light on the headset base turns off. The headset ON/OFF

light turns blue on the first headset registered and orange on

the second headset registered.

To verify the registration was successful, press the headset

ON/OFF button and check for a dial tone.

If the registration fails, the ON/OFF light on the headset

flashes twice every five seconds. To reset the headset, remove

the headset from the headset base and try the registration

process again.