User`s manual

28
Getting started
Adding and registering a headset
Option 1: To register a headset to your TL7612 headset base
Make sure the battery is properly installed in the
headset (see page 11). The ON/OFF light flashes
twice every five seconds to indicate the headset is
not registered.
Place the headset in the headset base or
charger and allow it to charge for at least five
minutes before registration.
Remove the headset from the headset base
or charger.
Press and hold the PAIR button until the
MUTE light on the headset base turns on
(about four seconds) and release the button.
Return the headset to the headset base
for registration.
It may take about 30 seconds to complete the registration. The
MUTE light on the headset base turns off. The headset ON/OFF
light turns blue on the first headset registered. The headset
ON/OFF light turns orange on the second headset registered.
To verify the registration was successful, press the headset
ON/OFF button and check for a dial tone.
If the registration fails, the ON/OFF light on the headset
flashes twice every five seconds. To reset the headset, remove
the headset from the headset base and try the registration
process again.
1.
2.
3.
4.
5.