User Manual

Getting started
9
Register a headset to the TL7810/TL7812 headset base
Make sure the battery is properly installed in
the headset (see page 6). The light flashes
slowly in red and blue to indicate the headset
is not registered.
Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
Remove the headset from the headset charger.
Press and hold the PAIR button on the
headset base (about four seconds) until
the MUTE light turns on and then release
the button.
Return the headset to the headset charger
for registration. The light flashes quickly
in red and blue.
It takes about 60 seconds to complete the
registration process. The light turns red
when the headset is registered but not fully
charged, or turns blue when it is registered
and fully charged.
If the registration fails, you hear the voice
prompt "Not registered" when you press the
button on the headset, and the light on the
headset flashes slowly in red and blue.
To reset the headset, remove it from the
headset charger and try the registration
process again.
NOTE: You cannot register a headset if another system headset is in use.
1.
2.
3.
4.
5.
Adding and registering headsets