User Manual

28
Operation
Headset ringer
The headset charger and headset do not have external ringers.
When you receive calls, the headset earpiece rings. If you have
telephones connected to the same telephone line as the headset
base, you can rely on the ringers of those telephones to alert
you to incoming calls.
To change the volume of the earpiece ringer:
Slide the volume switch at the top of the headset towards
VOL+ or VOL- when the headset is not in use.
To turn off the earpiece ringer:
Slide the volume switch at the top of the headset towards
VOL- until you hear two beeps when the headset is not in use.
Temporary ringer silencing
Press MUTE to temporarily silence the ringer in the headset
earpiece. This silences the ringer without disconnecting the call.
The next incoming call rings normally at the preset volume.
Call waiting
If you subscribe to call waiting service offered
by your telephone service provider, you will
hear a call waiting alert tone if someone calls
you while you are in the middle of a call.
Press down the FLASH switch at the top of
the headset to put your current call on hold
and answer the new call.
Press the FLASH switch again at any time to switch back and
forth between calls.
•
•
•
•
Headset operation