User`s manual

Adding and registering headsets

Make sure the battery is properly installed in

the headset (see page 3). The light flashes

slowly in red and blue to indicate the headset

is not registered.

Place the headset in the headset charger and

allow it to charge for at least one hour before

beginning registration.

Remove the headset from the headset charger.

Press and hold the PAIR button on the

headset base that is registering this headset

(about four seconds). When the MUTE light on

that headset base turns on, release the button.

Return the headset to the headset charger

for registration. The light flashes quickly

in red and blue.

It takes about 60 seconds to complete the

registration process. TheThe light turns red

when the headset is registered but not fully

charged, or turns blue when it is registered

and fully charged.

If the registration fails, you hear the voice prompt "Not

registered" when you press the button on the headset, and the

light on the headset flashes slowly in red and blue.

To reset the headset, remove it from the headset charger and try

the registration process again.

NOTE: You cannot register a headset if another system headset is in use.