User`s manual

7
Register a headset to the Synapse SB67030/SB67031 deskset
Press MENU on the deskset.
Scroll to User Settings, then press SELECT.
Scroll to Cordless Settings, then press SELECT.
Scroll to Headset, then press SELECT.
Make sure the screen shows Cordless Headset is currently
Not Registered before registration.
On the deskset, press Register. The screen displays
Registration in Progress... while the deskset is searching for
the headset.
Lift the headset from the headset charger, then replace it
to the charger. The headset light flashes red and blue to
indicate it is registering to the deskset.
When registration is complete, the screen displays Cordless
Headset is currently Registered.
It takes about 60 seconds to complete the registration process.
The light turns red when the headset is registered but not fully
charged, or turns blue when it is registered and fully charged.
To verify the registration, press the button on the headset and
check for a dial tone. If the registration fails, you hear the voice
prompt, "Not registered" and the light on the headset flashes
slowly in red and blue.
If the registration was not successful, remove it from the headset
charger and try the registration process again.
1.
2.
3.
4.
5.
6.
7.
Adding and registering headsets