User`s manual

45
Getting started
Adding and registering headsets
Register a headset to the headset base
Make sure the battery is properly
installed in the headset (see page
12). The light flashes slowly in red
and blue to indicate the headset is not
registered.
Place the headset in the headset base and
allow it to charge for at least one hour
before beginning registration.
Remove the headset from the headset base.
Press and hold the PAIR button (about four
seconds) until the MUTE light on the headset
base turns on and then release the button.
Return the headset to the headset base
for registration. The light flashes quickly
in red and blue.
It takes about 60 seconds to complete the
registration process. The light turns red when
the headset is registered but not fully charged,
or turns blue when it is registered and fully
charged.
If the registration fails, you hear the voice
prompt "Not registered" when you press the
button on the headset, and the light on the
headset flashes slowly in red and blue.
To reset the headset, remove it from the
headset base and try the registration
process again.
NOTE: You cannot register a headset if another system headset is in use.
1.
2.
3.
4.
5.