User`s manual

57
Appendix
Troubleshooting
Nothing happens when I move the corded handset audio
adjust switch.
• When the handset lifter is used, make sure the CORDED
HANDSET CONNECTED switch on the headset base is set
to YES. Slide the corded handset audio adjust switch at the
bottom of the headset base from A to F until you obtain good
sound quality.
My headset is ringing even when there is no incoming call.
The sensitivity level of your ring detector may be too high. See
page 27 to adjust the sensitivity level.
The ring detector may detect a sound from the environment
and send a ring tone to the headset. See page 27 to turn off
the ring detector.
When you are using the speakerphone of your telephone, the
ring detector may send a ring tone to the headset. If you do
not want the headset to ring, press the RING ON/OFF button
to turn the ring detector off. After the call, you can press the
RING ON/OFF button again to turn the ring detector back on.
Common cure for electronic equipment.
If the unit does not seem to be responding normally, try putting
the cordless headset in its base. If it does not respond, do the
following (in the order listed):
• Disconnect the power to the headset base.
• Remove the cordless headset battery.
• Wait a few minutes.
• Connect the power to the headset base.
• Install the battery again, and then place the cordless headset
into the headset base.
• Wait for the cordless headset to reestablish its connection
with the headset base. Allow up to one minute for this to
take place.
•
•
•