User Guide

12
Getting started
NOTE: The headset base and headset do not have external ringers. When
you receive calls, the headset earpiece rings. If you have telephones
connected to the same telephone line as the headset base, you can rely on
the ringers of those telephones to alert you to incoming calls.
Plug one end of the
telephone line cord into
the TEL WALL JACK
(red dot) at the back of
the headset base.
•
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
The DSL filter must be plugged
into a telephone wall jack.
Telephone line cord
Plug the other end of the
telephone line cord into
the line splitter.
•
Line splitter
Corded or
cordless phone
Plug the line splitter into
the telephone wall jack
(or a DSL filter if you
subscribe to DSL Internet
service).
•
Connect another
telephone line
cord between the
telephone and the
line splitter.
•
Use the attached
fastener to bundle
all line cords neatly.
•
Headset base installation
Option 1: Connect the headset to a telephone wall jack
Make sure the CORDED HANDSET
CONNECTED switch on the right side of the
headset base is set to NO.
Connect the line cords, as shown below.
Use the included line splitter to connect the
headset base and your telephone to the
same telephone wall jack.
1.
2.