User Guide

Operation
30
Caller ID announce
The Caller ID Announce feature lets you know who is calling
without having to look at the display. You have to install the
AT&T Softphone Call Manager on your computer to use the
Caller ID announce function. The software is available in the
CD-ROM which comes with the package. You may also visit
www.telephones.att.com/downloads to download and
install the software.
For detailed instructions of the caller ID announce feature, refer to
the Installation and Operation Guide, also available in the
CD-ROM which comes with the package or the web site stated
above.
Temporary ringer silencing
Press MUTE/VOICE to temporarily silence the ringer in the headset
earpiece. This silences the ringer without disconnecting the call.
The next incoming call rings normally at the preset volume.
NOTE: If you have more than one headset registered to the headset base,
both headset earpieces ring when there is an incoming call. Pressing
MUTE/VOICE on one headset only silences the ringer of that headset.
Call waiting
If you subscribe to call waiting service offered by
your telephone service provider, you will hear a
call waiting alert tone if someone calls you while
you are in the middle of a call.
Press down the FLASH switch at the top of
the headset to put your current call on hold
and answer the new call.
Press the FLASH switch again at any time to switch back and
forth between calls.
•
•
PHONE mode