User`s manual

Operation
29
End a call
When the headset base is connected to a telephone wall jack
(installation option 1):
Press on the headset or place the headset in the headset base.
When the headset base is connected to your corded phone
(installation option 2):
Hang up the corded handset, then press on the headset or
place the headset in the headset base.
Voice command
The voice command feature enables you to make or answer calls
using certain voice commands. You have to install the AT&T
Softphone Call Manager on your computer to use the voice
command function. The software is available in the CD-ROM
which comes with the package. You may also visit
www.telephones.att.com/downloads to download and
install the software.
For detailed instructions of the voice command feature, refer to
the Installation and Operation Guide, also available in the
CD-ROM which comes with the package or the web site stated
above.
Headset ringer
The headset base and headset do not have external ringers. You
can only hear the ringer through the earpiece when you are
wearing the headset. If you have telephones connected to the
same telephone line as the headset base, the ringers of those
telephones can alert you to incoming calls.
To change the volume of the earpiece ringer:
Slide the volume switch at the top of the headset towards
VOL+ or VOL- when the headset is not in use.
To turn off the earpiece ringer:
Slide the volume switch at the top of the headset towards
VOL- until you hear two beeps when the headset is not in use.
•
•
•
•
PHONE mode