User`s manual

Appendix

Adding and registering headsets

Make sure the battery is properly installed in

the headset (see page 9). The light flashes

slowly in red and blue to indicate the headset

is not registered.

Place the headset in the headset base and

allow it to charge for at least one hour before

beginning registration.

Remove the headset from the headset base.

Press and hold the PAIR button (about four

seconds) until the MUTE light on the headset

base turns on and then release the button.

Return the headset to the headset base

for registration. The light flashes quickly

in red and blue.

It takes about 60 seconds to complete the

registration process. The light turns red when the

headset is registered but not fully charged, or turns

blue when it is registered and fully charged.

If the registration fails, you hear the voice

prompt "Not registered" when you press the

button on the headset, and the light on the

headset flashes slowly in red and blue.

To reset the headset, remove it from the headset

base and try the registration process again.

NOTE: You cannot register a headset if another system headset is in use.