Operation Manual

66
Answering system
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code to any number from 00 to 99.
Using the telephone base:
1. Press the MENU soft key when the telephone base is not in use.
2. Press the SELECT soft key to select to select Answering sys.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then
press the SELECT soft key.
5. Press qCID or pDIR to scroll toto scroll to Remote code, then
press the SELECT soft key.
6. Use the dialing keys (0-9) to enter a two-digit code.
Press CANCEL to delete a digit.
7. Then p ress the SET soft key to confirm your setting.
There is a confirmation tone.
Using the handset:
1. Press the MENU soft key when the handset is not in use.
2. Press the SELECT soft key to select ANSWERING SYS.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2
, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then press
the SELECT soft key.
5. Press qCID or pDIR to scroll to Remote code, then press
the SELECT soft key.
6. Use the dialing keys to enter a two-digit code. Press OFF
to delete a digit.
7. Then press the SET soft key to confirm your setting. There
is a confirmation tone. Or press the BACK soft key to exit
to the previous menu without making any changes.
NOTE: If you change the remote access code setting on either Mailbox 1 or Mailbox 2, it
applies to both mailboxes in your answering system.
1
# of rings
Remote code
Msg alert tone
SELECT
1
REMOTE CODE
__
SET
1
BACK
SET
REMOTE CODE
__
1
BACK
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone