Powered by AT&T Remote Monitor STARTER KIT USER’S MANUAL ///
INTRODUCTION TO YOUR REMOTE MONITORING STARTER KIT /// HARDWARE INSTALLATION: Thank you for your purchase of the Remote Monitoring Starter Kit. The XG1000 Controller, a small dedicated computer, allows you to access and control cameras and other devices in your home, and make this information available to you wherever you are. You can access the XG1000 from any PC (must be running Windows XP, Vista, 2000 or Mac OSX) with an internet connection anywhere in the world.
FOLLOW THE STEPS BELOW SET UP YOUR ENHANNCED REMOTE MONITORING STARTER KIT: 1. Take the XG1000 Controller AC Power Supply from your Controller box. Plug the small end into the port marked Power on your XG1000 Controller and plug the other end into an AC electrical outlet. 4. Plug the small end of the AC Power Supply into your IPC-1000 IP Camera AC Adapter port and the other end into an AC electrical outlet. Example of completed configurations can be found below. 2.
. Bring your IP Camera, AC Power Supply, HomePlug Turbo PLC Ethernet Adapter, and Ethernet Cable to the location in your home that you wish to install your IP Camera. Connect one end of the Ethernet Cable to the LAN port of the IP Camera and connect the other end to the port on the bottom of the HomePlug Turbo PLC Ethernet Adapter. Plug the HomePlug Turbo PLC Ethernet Adapter into an AC electrical outlet. CONTROLLER REGISTRATION: 1.
4. When the controller registration has completed, you will see a confirmation message as in the following picture. After you successfully register your controller you may be prompted to follow instructions in order to improve performance USING THE SYSTEM WITH A CORPORATE FIREWALL /// If you are using the Remote Monitoring system in an environment that is protected by a corporate firewall, you may need to make some settings that will allow you to get the best performance out of your system.
LIVE VIDEO /// For each discovered camera you will see a Snapshot of the view associated with the camera when you click on the ‘LIVE VIDEO’ tab. This snapshot image is for identifying the camera; it is not updated in real time. The snapshot view for each camera can be refreshed by clicking the ‘REFRESH’ button in the upper right corner of the image. Click on a camera snapshot to view live video from that camera.
XG1000 CONTROLLER /// INDICATORS: There are ten indicators on the front of the controller. BOOT SEQUENCE When the controller is first powered up, the bottom five LED’s on the front panel go through a boot-up sequence. The lights start out as Red, go to Amber and then Green. The process takes about three minutes. REAR PANEL: The rear panel of the controller contains the ports for cable connections. The bottom round port is for the power. The AC adapter is plugged into this port.
MOBILE OPTION: You can access the system from just about anywhere with a web-enabled cell phone. Just use your phone’s web browser to download and install the application from http://xanboo.com/mobile/j2me (with a JAVA enabled phone) or from http://xanboo.com/mobile (if your phone is not JAVA enabled) and enter your Remote Monitoring User ID and Password when prompted. Data rates will apply, so you may want to consider subscribing to a data package.