Operation Manual

ATAG timer thermostat page FRONT KEYS
The functions under the
key are, if required,
permanently displayed
on the display. To do
this you should keep the
key pressed for 10
seconds for the function
in question. Return to
the standard display by
pressing the key as
often as necessary.
7
Functions:
retrieving:
- booster function, on / off (if CH program and adaption are set to "ON")*
- outside temperature (if an outside sensor is connected)
- flow water temperature
- hot water temperature
(for an external DHW with temperature sensor and if HW program is set to "ON").
- burner power in %
- thermostat for CH, on / off (if CH program and adaption are set to "ON")
- water pressure installation
- CH progran, on / off *
- HW program, on / off *
- pump program, on / off *
Each time that you press the
key another function can be seen on the display.
The standard display appears five seconds after releasing the
key.
* The programs "booster", "CH prog", "HW prog" and "pump prog" can be switched on or off using the and
keys. The booster function can be switched on if it is necessary to accelerate warm-up of the installation.
After completing the warm-up, this program automatically switches off and the set program becomes active
again. The programs "CH prog", "HW prog" and "pump prog" have the same function as the on / off keys on the
heating appliance.