Operation Manual

ATAG timer thermostat page
You can use the key at any time to request information on the status of your heating appliance and the outside temperature (if ATAG
outside temperature sensor is connected) without thereby affecting the operation of your heating appliance.
You should also take into account that for each change which you set in the Brain, a few seconds may be needed to process the information
before the display actually depicts this change.
You want to have the night temperature
continuous for an indefinite period.
Manual operation.
You want to
undo the above settings
and revert to the normal settings.
You want hot water outside of the clock
program. (Thus at times, e.g. at night,
when there is no hot water supply). Max
2 hours.
- Press the
key for 6 seconds until LOWER CONT is displayed. When you
release the key, the heating will maintain the night temperature for an
indefinite period of time (
flashes).
- By selecting HEATING CONT or LOWER CONT, as described above, it is
possible to manually regulate the temperature 24 hours a day using the
and keys.
- Press the or key until AUTOMATIC is displayed. When you release
the key, the normal program will once again be active.
- Press the and keys at the same time until PAST LOAD DHW ON is
displayed. To switch it off again early, you press the
key after selecting
PAST LOAD DHW ON.
page 9
page 7
and
page 9
page 6
and
page 8
page 9
5 IN BRIEF