Operation Manual

EN 32
3. Remove the frothed milk regulator (F) by pulling it outwards.
4. Wash all the components thoroughly with hot water and mild
washing-up liquid. Make sure there are no milk residues left inside
the holes (H) and the groove (G) on the fine end of the frothed milk
regulator (F).
5. Check that the intake tube and spout are not clogged with milk
residues.
6. Replace the frothed milk regulator, milk spout and intake tube.
7. Replace the milk container lid.
Cleaning the spouts
Clean the spouts on the milk container every time after heating milk or
making cappuccino. Otherwise, remains of milk may set hard.
• Place a container under the milk dispenser pipe and press on the
CLEAN button (N3) on the milk container for at least 5 seconds.
The display shows “CLEANING”!
Warning! Risk of scalding from steam and hot water escaping from
the milk dispenser pipe.
MAINTENANCE
G
F
H
H
N3