Operation Manual

EN 11
SAFETY INSTRUCTIONS
Installation of this oven must be performed only by
a licensed electrician. The installer is responsible
for connecting the appliance to the mains power
supply in observance of the relevant safety
recommendations.
Electrical safety
• If the oven has been damaged in transport, do
not connect it.
• This appliance must be connected to the mains
power supply only by a specially licensed
electrician.
• In the event of a fault or damage to the
appliance, do not attempt to operate it.
• Repairs should be performed by a licensed
technician only. Improper repair may result in
considerable danger to you and others. If your
oven needs repair, contact the Atag Customer
Service or your dealer.
• If the supply cord is defective, it must be
replaced by a special cord or assembly available
from the manufacturer or an authorised service
agent.
• Electrical leads and cables should not be
allowed to touch the oven.
• The oven should be connected to the mains
power supply by means of an approved circuit
breaker or fuse. Never use multiple plug
adapters or extension leads.
• The rating plate is located on the inside of the
oven on the right side.
• The power supply of the appliance should be
turned off when it is being repaired or cleaned.
• Take care when connecting electrical appliances
to sockets near the oven.
• WARNING: The appliance and its accessible
parts become hot during use. Care should