Operation Manual

EN 15
1. Fix the oven on both sides using screws.
2. After installation, remove the vinyl protective film from the door to
the appliance and the protective film from the interior surfaces of
the oven.
Connecting to the mains power supply
• Electrical connections must be made as per the connection plate
fixed to the back of the appliance by an electrical fitter who must
ensure that the appliance has been connected up in accordance
with fitting instructions and local regulations.
• Where the appliance is not connected to the mains electricity
supply by a plug, an omni polar cutout device (with a contacts
gap of at least 3 mm) must be fitted on the supply side of the
connection to meet safety requirements.
Note
• When the power is connected, the electronics of the oven are
initialised; this neutralizes the lighting for a few seconds. The
electric cable (H05 RR-F or H05 VV-F, Min. 1.5 m, 1.5~2.5 mm²)
must be long enough for it to be connected to the built-in oven
standing on the floor in front of its unit. Open the back cover of the
oven at the bottom (using a flat-bladed screwdriver) and completely
unscrew the connection screw and the cable clamp before fitting
conducting wires into the appropriate terminals.
• The earth wire must be connected to the (
) terminal of the oven.
• If the oven is connected to the power supply by a plug, this must
remain accessible once the oven has been fitted.
• We cannot accept any liability in the event of an accident resulting
from non-existent or faulty earthing.
INSTALLATION AND CONNECTION
Live
Neutral
Earth