Operation Manual

GB 16
MAINTENANCE
Active carbon filters:
The active carbon filters are used to purify the air that is sent back
into the room and its function is to mitigate the unpleasant odours
produced by cooking. Regenerable active charcoal filters must
be washed by hand, with non abrasive neutral detergents, or in
the dishwasher at a maximum temperature of 65 °C (the washing
cycle must be complete without dishware). Remove excess water
without damaging the filter, remove the stainless steel casing, and
let the mat dry in the oven for at least 15 minutes approximately at a
maximum temperature of 100 °C. To keep the regenerable charcoal
filter functioning efficient this operation must be repeated when the
indicator starts flashing. The charcoal mat must be replaced at least
every 3 years or when the mat is damaged. Before remounting the
anti-grease filters and the regenerable active charcoal filters it is
important that they are completely dry. To transform the hood from a
ducting version into a filtering version, ask your dealer for the charcoal
filters and follow the installation instructions.
Substitution of active carbon filters:
To replace the active carbon filters you must remove the antigrease
filters and then, press the two buttons on the side B of the active
carbon filter into the interior. To remove the filter pull it down. To
reassemble the part, simply perform the procedure in reverse.
To replace a halogen bulb B, press the glass cover C as shown in figure 1
.
Attention:
Replace the halogen bulb with one of the exact same type. Do not
touch a halogen bulb with bare hands, and make sure you put the glass
cover C (figure 2) back in place after replacing the bulb.
Attention!
If instead the hood is fitted with LED bulbs, these have to be replaced
by a specialized technician. Do not attempt to replace LED bulbs
yourself.







Fig.1
Fig.2