Installation guide

GB 21
FAULTS Faults table
FAULT CAUSE SOLUTION
A burner does not ignite. Control knob not kept
pressed in far enough.
(Only for B versions. For
electronically protected
appliances, see the On/Off
button table).
Keep the control knob
pressed in far enough
between full and low. At
first use this can take some
more time because of the gas
supply.
e burner does not burn
evenly.
Burner parts incorrectly
installed.
Burner parts dirty or damp.
Wrong type of gas used.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Check that the gas used is
suitable for the appliance. If
not, contact your gas fitter.
e burner goes out after
igniting.
Control knob not kept
pressed in long enough.
(Only for B versions. For
electronically protected
appliances, see the On/Off
button table).
Keep the control knob
pressed in for at least
5 seconds.