Operation Manual

GB 31
SYMPTOM
POSSIBLE CAUSE SOLUTION
You have switched a cooking
zone on but the display keeps
fl ashing.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
Use a suitable pan
(see page 13 and 14).
A cooking zone suddenly
stops working and you hear a
signal.
The preset time has ended. Switch the bleep off using the
or button on the timer.
The hob is not working and
nothing appears in the display.
There is no power supply due
to a defective cable or a faulty
connection.
Check the fuses or the electric
switch (if there is no plug).
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Check the electrical
connections.
Fault code E6. The hob has been wrongly
connected.
Check the electrical
connections.
Fault code F00. The control panel is dirty or
has water lying on it.
Clean the control panel.
Fault code F0 ... F6 and FC. Defective generator. Contact the service
department.
Fault code F7. The ambient temperature is
not good.
Switch off all heat sources in
the vicinity of the cooking
plate.
Fault code F8 and F08. Appliance over heated. The appliance has been
switched off because of over
heating. Let the appliance
cool down and start again on
a lower setting.
Fault code F9 and/or
continuous beep.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Let your connection be
changed.
Fault code F99. You have pressed two or more
buttons at the same time.
Do not operate more than
one button at the same time.
Fault code FA. Mains voltage is too low. Contact your energy supplier.
Fault code FAN. Air circulation not good. Make sure the venting holes
under the cooking plate are
open.
Other fault codes. Defective generator. Contact the service
department.
General
TROUBLESHOOTING