Operation Manual

warning
Before cleaning, remove the plug from the socket.
Never pull the plug out of the socket by the cable.
warning
– Never use a steam cleaner for cleaning the
fridge/freezer combination. This is dangerous.
– Do not use too much moisture.
– Avoid moisture penetrating electrical parts.
– Do not wash plastic parts in the dishwasher; they
are not dishwasher-resistant.
drip tray under dispenser
If water gets into the drip tray, dry the drip tray
immediately, so that no deposits can form in it. If
spots do form, leave the tray to soak for 30 minutes
in undiluted vinegar or in a solution of one
teaspoonful of citric acid and half a litre of warm
water. Dry the tray thoroughly with a soft cloth.
dispenser switch
Clean this with a solution of one tablespoonful of
bicarbonate of soda and one litre of water. Rinse it
well in water and dry it.
exterior, handles and decorative trim
strips
Clean with a damp cloth and suds of a washing-up
liquid. Dry with a soft cloth. Do not use any
aggressive cleansing agents, such as abrasives,
scour
ers, bleach or cleansing agents which contain
bleach. These products may damage the paint or
cause scratches.
cleaning exterior of appliancechanging light bulbs
warning
Disconnect the appliance from the power supply
before changing a light bulb. Remove the plug from
the socket.
refrigerator section, top
1. Remove the plug from the socket.
2. Remove the protective cover.
3. Replace the light bulb with a new one (230 V,
40W).
4. Replace the protective cover.
5. Insert the plug in the socket and switch on the
fridge/freezer combination.
refrigerator section, bottom (if applicable)
1. Remove the plug from the socket.
2. Remove the protective cover firmly. Then lift it
up, push it forward and remove it.
3. Replace the light bulb with a new one (230 V,
40W).
4. Replace the protective cover.
5. Insert the plug in the socket and switch on the
fridge/freezer combination.
freezer section with dispenser
1. Remove the plug from the socket.
2. Remove the rack under the light (an empty rack
will be easier to remove).
3. Pull the protective cover towards you.
4. Replace the light bulb with a new one (230 V,
40W).
5. Replace the protective cover.
6. Replace the rack.
7. Insert the plug in the socket and switch on the
fridge/freezer combination.
grasp the cover on the right and pull it downwards