User manual

Problem Possible cause Solution
The temperature regulator is not
set correctly.
Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension of the recess
Height 1030 mm
Width 560 mm
Depth 550 mm
Rising Time 26 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
Installation
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the door, you must ensure that it is
made unusable to prevent young
children being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Your appliance must be connected to a sin-
gle-phase supply of 230 V. Check that the
electricity meter is suitable for the power
consumed by your appliance, allowing for
the other connected appliances. Rating of
the in-line fuses (one per phase): 10 A at
230 V.
Important! Installation must be done in
conformance with the applicable codes, the
requirements of the standard NF.C.15100
and the requirements of the electrical
energy supplier.
Use a power supply socket that has an
earth connection and this must be connec-
ted in conformance with the standard
15100 and the requirements of the supplier
of electrical energy. this power supply sock-
et must be accessible. If the mains supply
cable is damaged, it must be replaced by a
certified supply cable. This must be done
only by a skilled person, the seller or the
manufacturer. The appliance must not be
connected via an extension cable, a multi-
ple socket or a multiple connector (risk of
fire). Make sure the earthing connection
complies with the regulations in force.
We will accept no responsibility in the event
of accidents or incidents caused by non-ex-
istent or defective electrical earthing con-
nections.
22