User manual

ATAG 67
Oven shelves and telescopic runners
Before proceeding ensure the oven is
cool and disconnected from the electric-
ity supply.
The shelf support rails on the left and right hand sides
of the oven can be removed for cleaning the side
walls.
Removing the shelf support rails
First pull the front of the rail away from the oven wall
and then unhitch at the back.
Fitting the shelf support rails
To install, first reattach the rails at the back, then put
them into position at the front and press them into
place .To clean the shelf support rails, soak in warm
soapy water and remove stubborn marks with a well
wetted soap impregnated pad. Rinse well and dry
with a soft cloth.
Cleaning
Clean the set of shelf supports with telescopic rails
on the outside only with commercially available
detergents. Rinse well and dry with a soft cloth.
The telescopic rails must not be cleaned
in the dishwasher.
When cleaning the shelf supports, take care
not to remove the lubricating grease behind
the telescopic runners. This is meant to ensure
their good operation.
If necessary, it is possible to reverse the
oven door. This operation should be carried
out by authorized personnel ONLY.
Please find the separate instruction.
Customers are recommended not to carry
out this operation themselves. Complaints
as a result of changing the appliance are
excluded from the guarantee.
ATAG supplies a range of cleaning agents
under the name of ATAG Shine.
You may order these on www.hps.nl. This
site also contains several tips on cleaning
and operating the appliance.