User manual

62 ATAG
gradually heat up until the selected temperature is
reached. This will take from 10 to 15 minutes,
depending on selected function and temperature.
If it is necessary to reach the required temperature in
a shorter time, the fast heat up function can be used.
1. Switch the oven on by pressing the "ON/OFF"
button .
2. Set the required cooking function and
temperature as described in the previous pages.
3. Wait few seconds till the symbol "}" stops
flashing.
4. Press the "BOOSTER" button . The
temperature display shows "
FHUFHU
FHUFHU
FHU" (Fig. 18).
5. If you press the "MENU" button , the
temperature display reverts to the selected
temperature and symbol "}" flashes for 5 seconds
(Fig. 19). During this interval, you can adjust the
temperature setting by turning the TEMPERATURE/
TIME knob.
6. When the required temperature is reached,
the Electronic Control beeps for a short time, and the
temperature display reverts to the selected
temperature.
This function can be used with any cooking function
or temperature.
This function cannot be used with recipes function .
)
Residual Heat Function
When a Cooking Duration time is set, the heating
elements of the oven will automatically go off a few
minutes before the end of the programmed time,
and the oven will use the residual heat to finish your
dishes without energy consumption. All current
settings will be displayed until the Cooking Duration
time is over.
This function will not operate when the Cooking
Duration time is less than 15 minutes.
Fig. 18
Fig. 19
turbo fan coo