Operation Manual

41
Dismantling and loss of voltage
Loss of voltage
The thermostat works without batteries and obtains its required
energyviatheboiler.Whenthethermostatisremovedfrom
itsmountingplate,allsettingsarestoredinthememory.Only
after an interruption of approximately 4 hours do you have to
reset the day and time.
Dismantling
Disconnect the boiler from the mains (pull the plug
from its socket or use the on/off button).
•Thethermostathingesatthetopandisclamped
at the bottom (in the middle).
Remove the thermostat from its mounting plate by
rmlygrabbingholdofitwith2handsandreleasing
the bottom by pulling it forward.
Retting
•Hookthetopofthethermostatonthemounting
plate and tip it downwards until it snaps at the
bottom.
•Reconnecttheboilertothemains.Set,when
the thermostat asks you to do so, the correct time
and day and the thermostat will be ready for use
again. Bear in mind that it may take a while before
the boiler is back on standby due to the automatic de-aeration
program. Depending on the boiler type this may take between
7 and 17 minutes (refer to the boiler’s manual).
•Refertochapter5.7forexplanationsregardingsettingthe
correct day and time.