User's Manual

ManualsBrandsATBS Technology ManualsElectronicsBLE TPMS

AT63 sensor User’s guide

1. Introduction

This AT63 BLE sensor is a type of sensor that

combined TPMS and cellphone. AT63 TPMS external

sensor adapts BLE low energy transmission, let driver

understand tire situation through cellphone. When the

system detects tire pressure or temperature abnormal

situation, it (APP) will directly alarm the driver.

About This Manual：

 The information in this manual is subject to change

without notice.

 This manual has been created with extra care. In case

that you have any comments or questions regarding

this manual, please contact your local dealer or our

Customer Service Center.

 Before operating this set, please fully understand the

prerequisite such as specifications or constraints of

the hardware and software. We are not responsible

and have no liability for any loss, damage or injury as a

result of misuse.

2. Check Accessories

Model

Photograph

AT63 sensor

Battery

Lock nut

Wrench

Userguide

3. System installation

3.1 Install sensor(battery changeable)

3.1.1 Place batteries into the sensor and screw the top

cap off. Please attend to the electrode of the battery.

3.1.2 Remove original valve cap and screw lock nut (1)

and will become (2). Screw the Sensor onto valve stem

clockwise (3). Screw (1) lock nut back and use wrench

to lock tightly (4). (3)(4) steps could effectively prevents

sensor from removing.

3.1.3 The sensor label already indicates the sensor ID

and its wheel order, please follow the wheel order to

install sensors.

EX :

Sensor Model: AT63

ID:810C619A

Note

：

(1) Beware of the conductivity between the sensor

and valve stem.

(2) Sensors are supposed to be well locked valve

stem to avoid from leaking.

(3) Please replace original manufacturer’s sensor

battery in case voltage is below 2.7v.

(4)External sensor will transmit data every 58~62

seconds when the vehicle is running, and when

the vehicle stops, the sensor will transmit data

every 148~152 seconds.

Summary of content (4 pages)

PAGE 1
AT63 sensor User’s guide 3.1.2 Remove original valve cap and screw lock nut (1) 1. Introduction This AT63 BLE sensor is a type of sensor that and will become (2). Screw the Sensor onto valve stem combined TPMS and cellphone. AT63 TPMS external clockwise (3). Screw (1) lock nut back and use wrench sensor adapts BLE low energy transmission, let driver to lock tightly (4). (3)(4) steps could effectively prevents understand tire situation through cellphone. When the sensor from removing.
PAGE 2
4. iTPMS APP Installation: iTPMS App is for free. Through the iTPMS you can know tire temperature and pressure, sensor battery voltage, and each sensor’s ID. 4.2 App Operating 4.2.1 Click below ID, and enter the ID learning page, start to learn the sensor ID. 4.1 Install APP (Take IOS as example) 4.1.1 Download the APP: iTPMS BLE from Apple Store or Google Play. 4.1.2 Go to Setting => General => Bluetooth Page. 4.1.
PAGE 3
4.2.4 In the meantime, this TPMS program also afford user to manual input the ID function and scanning QR function, please refer to the following steps: A) Manual key in ID steps: 1) Click the right upper “Edit” B) Steps for scanning QR Code: 1) Click middle QR buttom 2) Enter into ID Read page, and click the blank to start scanning QR code. And then click save. 2) Turn to New page 3) Click the blank and appear keyboard, enter the ID and 3) Click “Yes” 4) Click SAVE and then click save.
PAGE 4