Specifications

Sheet 18 of 39 Document 12245 Rev. I
Message Table
Instr
Sub-
Instr Name/(Section)
Data Values
 Sent to Amplifier  Returned by Amplifier
B
MUTE_CONTROL
= 30 for MUTE (Output off), = 31 for OPERATE (Output on)
18 51
Redundancy Mode
(3.10.2)
To set redundancy mode:
 B
REDUND_MODE
 None
B
REDUND_MODE
= 30 for MANUAL, = 31 for AUTO, = 32 for SPARE.
To read current setting:
 None
 B
REDUND_MODE1
B
REDUND_MODE2
B
REDUND_MODE1
= 30 for MANUAL, = 31 for AUTO or SPARE.
B
REDUND_MODE2
= 30 for MANUAL, = 31 for AUTO, = 32 for SPARE.
B
REDUND_MODE1
is returned for compatibility with earlier SSPA products.
18 52
Gain Control
(3.10.3)
To set gain:
 ±N
GAIN
 None
To read current gain setting:
 None
 ±N
GAIN
18 53
Control Unused Parallel
Outputs (3.10.4)
To set:
 B
PIO_UNUSED_OUTPUT_CONTROL_R1
[ B
PIO_UNUSED_OUTPUT_CONTROL_R2
[ B
PIO_UNUSED_OUTPUT_CONTROL_R3
[ B
PIO_UNUSED_OUTPUT_CONTROL_R4
[ B
PIO_UNUSED_OUTPUT_CONTROL_R5
[ B
PIO_UNUSED_OUTPUT_CONTROL_R6
[ B
PIO_UNUSED_OUTPUT_CONTROL_R7
[ B
PIO_UNUSED_OUTPUT_CONTROL_R8
] ] ] ] ] ] ]
 None
To read back:
 None
 B
PIO_UNUSED_OUTPUT_CONTROL_R1
B
PIO_UNUSED_OUTPUT_CONTROL_R2
B
PIO_UNUSED_OUTPUT_CONTROL_R3
B
PIO_UNUSED_OUTPUT_CONTROL_R4
B
PIO_UNUSED_OUTPUT_CONTROL_R5
B
PIO_UNUSED_OUTPUT_CONTROL_R6
B
PIO_UNUSED_OUTPUT_CONTROL_R7
B
PIO_UNUSED_OUTPUT_CONTROL_R8
B
PIO_UNUSED_OUTPUT_CONTROL_Rx
= 30 to leave unchanged (when setting),
31 for Normally Open,
32 for Normally Closed.
18 54
Power Units
(3.10.5)
To set units of measurement:
 [B
POWER_UNITS
]
 None
To read currently set units of measurement:
 None
 [B
POWER_UNITS
]
B
POWER_UNITS
= 30 for dBm, = 31 for dBW, = 32 for Watts
18 55
Reflected Measurement
Type
(3.10.6)
 [ B
REFLECTED_MEAS_TYPE
]
 [ B
REFLECTED_MEAS_TYPE
]
B
REFLECTED_MEAS_TYPE
= 30 for Power (in currently set power units,
31 for Return Loss (in dB),
32 for .VSWR (as a numeric ratio :1)
19 52
1:1 Switch Command
(3.11.1)
 B
1-1_SW_COMMAND
 None
B
1-1_SW_COMMAND
= 30 to switch this unit on-line
31 to switch the other unit on-line
41 to switch Unit 1 on-line
42 to switch Unit 2 on line.