User's Manual

Hub Tool Instructions

1. 1999 Ford F-350 Pickup

Crew Cab Diesel 7.3 LTR

4. Put two screws in as

shown. Push in to release

tension spring.

3. Remove manual locking

hub (This is a Warner Hub

Assembly).

2. Remove lug nuts and

wheel.

5. Remove spring clip.

8. The hub is now removed.7. Pull the hub out.6. Remove snap ring from

axle shaft.

9. Remove caliper and caliper

mount.

12. Remove the nuts holding

the bearing assembly. The

nuts are 21 mm thin wall

socket.

11. Remove the brake rotor.

10. Support caliper to protect

brake hose using a bungee

cord or set on leaf spring.

13. Turn steering wheel to the

right and tap on the tool. Turn

back to the left and tap again.

Go back and forth until the

bearing is removed.

16. The U-joint had to be

turned out.

15. When using either the

Dodge attachment, or the

Hub Tool alone, if the tool will

not thread on, turn the axle to

reposition the U-joint, then it

will thread on.

14. Bearing assembly. 17. Reinstalled.

Ford and Dodge 4WD Hub Tool

ATD-8641

PAGE 1
ATD-8641 Hub Tool Instructions Ford and Dodge 4WD Hub Tool 1. 1999 Ford F-350 Pickup Crew Cab Diesel 7.3 LTR 2. Remove lug nuts and wheel. 3. Remove manual locking hub (This is a Warner Hub Assembly). 4. Put two screws in as shown. Push in to release tension spring. 5. Remove spring clip. 6. Remove snap ring from axle shaft. 7. Pull the hub out. 8. The hub is now removed. 9. Remove caliper and caliper mount. 10. Support caliper to protect brake hose using a bungee cord or set on leaf spring. 11.