User's Manual

3
MAINTENANCE
Periodically inspect the air tank. Ensure that all parts
move freely. Inspect the air hose for cracking and abrasions.-
Inspect tank for dents, craks, and rust.
Do not attempt to weld or repair a damaged tank.
Replace damaged components ONLY!
(See Replacement Parts section below)
Cleaning
Clean as needed and wipe with a dry cloth.
Storage
When not in use, shut off the air valve by turning the
red knob clockwise. Store indoors, do not expose to
moisture or heat radiation.
• Read, understand and follow all printed materials
provided with and on this device before use.
• RISK OF BURSTING - Do not exceed rated
pressure of 125 psi.
• Fill only from low pressure compressor systems
whose pressure is no greater that 150 psi. Fill
• Do not adjust or tamper with factory preset
pressure relief valve.
• Do not operate air tank with damaged or missing
parts.
parts only.
.
• Do not attempt to weld or repair a damaged
tank.
•
if it is dented, cracked, rusted or
otherwise damaged in any way.
•
Always wear safety goggles when handling or
using this equipment.
•
Store indoors, do not expose to moisture and/or
direct sunlight.
• RISK OF INJECTION - Attachments are NOT
recommended for use with this air tank.
Never direct stream of air at person(s). Always
wear safety goggles.
• RISK OF FIRE OR EXPLOSION
-
Do not use to
store or disperse
liquids, gasses or materials of any kind.
•
Never use this portable air tank past the discard
date stamped into the bottom of the tank.
Failure to heed these markings may result in
personal injury and/or property damage
REPLACEMENT PARTS
Not all components of the air tank are replacement
items, but are illustrated as a convenient reference of
location and position in the assembly sequence. When
ordering parts, give model number, serial number and
description below. Call or write for current pricing:
ATD Tools Inc., Tel:[phone] Fax:[phone]
! WARNING
Part No. Description Qty
ATD9892
Gauge
1
ATD9893
Manifold
1
ATD9894
Hose Assy
1
OPERATION
Filling Air Tank: (ref. Fig 1 on page 2)
1. Fill the air tank by connecting an air source to the air
tank manifold. Monitor air pressure gauge movement.
Do not exceed rated air pressure of 125 psi.
2. Open the air valve by turning the knob counter-
clockwise, pressurizing the air hose. Your air tank is
now ready for use.
Figure 2 - Air Tank Replacement Parts
Gauge
Manifold
Air Hose
only with filtered and dried shop air.
Replace components with factory authorized
Replace tank