Specifications


Lockthetoolinthe“on”position
1) Whenstartingholdthetoolfirmlywithbothhandsi.e.onehandonthemotorhousingandtheother
onthesideauxiliaryhandle(1).
2) Start the tool bypressing triggerinwards, and then press thelock button atside to
lock the toolat
“on”condition.Inthiscondition,thetoolwilloperatecontinuouslywithoutpressingthetriggerallthe
time(Seefigure5)
3) Stopthetoolbyactuatingtheswitchtriggeragain.

4.Operatinginstructions

Note:
Thisanglegrindercanbeusedforgrindingsteel,stoneorceramicworkpiecessuchaspipe,boxsection,
rectangular,angleironsteelbar,householdbricksandtiles.Donotattempttogrindwoodorasoftmetalsuch
aslead.Thematerialwillquickly“fill”thediscand
renderituseless.
Beforestartingthegrinderfirstensurethatthedisc,discguardandtoolareingoodcondition.Positionthe
guardsothatitwilldeflecthotsparksawayfromtheoperator.

1) Donotcoverventswhenthetoolisinuse.Thismaycausedamageto
themotorandreducetheefficiency
ofthetool.
2) Guidebackandforthovertheworkpieceinasteadymotion.

Grinding
Thebestresultsareachievedwithanangleof20
0
to30
0
forgrinding.Movethe
machinebackandforthwithlightpressure.Inthismanner,theworkpiecedoesnot
becometoohot,nodiscolorationoccursandnoridgesareproduced.
Undernocircumstancesshouldacuttingdiscbeusedforroughingwork.




5.Maintanceandinspection
1) Thearmatur e and  stator(motor)isthe heartof thepower tool. Exerciseduecare toensure theydonot
becomedamagedoraffectedbyoilorwater.
2) Inspectthecarbonbrushesregularlyandreplacewhentheyarewornupaboutonethird.
3) Regularly inspect all mountings and
 screws and ensure they are properly tightened. Showed any of the
screwsbeloose,tightenthemimmediately.Failuretodosomayresultinseriousdamage.
4) The supply cord of the tool  and any extension cord used should be checked frequently for damage. If
damaged, have the cord set
replaced by an authorized service facility. Replace the extension cord if 
necessary.
5) The grease in the gearbox will require replacement after extensive use of the tool. Please refer to an
authorizedserviceagenttoprovidethisservice.
6) Consultanauthorizedserviceagentintheeventoffailure.
7) Clean
anddustthetoolaftereachuse.


6.Accessories

CAUTION:Theseaccessoriesorattachmentsarerecommendedforusewithyourtoolspecifiedinthismanual.
Theuseofanyotheraccessoriesorattachmentsmightpresentariskofinjurytopersons.Onlyuseaccessory
orattachmentforitsstatedpurpose.

Auxiliaryhandle1pc
Spanner1pc
InnerHex.Spanner1pc

GrindingWheel1pc 
