ATD‐10512 7” Angle Grinder Instruction Manual Caution: Read this instruction manual before using this tool. Specifications Voltage: 120V/60Hz Amps: 11A No Load Speed: 7,800 RPM Max Accy Diameter: 7” Arbor Hole Diameter: 7/8” Safety Lock‐Off Switch: Yes Spindle Lock: Yes Spindle Thread: 5/8”‐11 Cord Length: 6’ Tool Weight: 6.
General Power Tool Safety Warnings WARNING Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains‐operated (corded) power tool or battery‐operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
l) Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. m) Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. n) Regularly clean the power tool’s air vents.
ADDITIONAL SAFETY REGULATIONS Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments. Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. Hold tool by insulated gripping surfaces when performing an operation where the cutting tools may contact hidden wiring or its own cord.
1. Introduction This tool is intended for grinding and deburring metal materials without the use of water. Do not apply pressure on the tool; let the speed of the cutting disc do the work Read and save this instruction manual. Tool specifications: Model ATD‐10512 Voltage (V) Frequency (Hz) Rated Current (A) No‐load speed (Min‐1) Disc dia. (mm) Spindle Thread 60 11 7800 7” 5/8” 120 1. Auxiliary handle 2. Spindle lock button 3. On/off switch 4.
2. Assembly Warning: Switch off the grinder and disconnect it from the power point. 1) The auxiliary handle (1) can be screwed to the left or the right of Gear Box. Select the position which gives the most comfortable and safe use. 2) Fitting the grinding guard: (See figure 1 and 2) A: Position the lug on the inside of the central guard ring in the vertical in the spindle cover then Place the Wheel guard cover and right the hole; B: The guard shall be position in the neutral position.
3. Operation Switch On/off the tool 1) When starting hold the tool firmly with both hands i.e. One hand on the motor housing and the other on the side auxiliary handle (1). 2) Start the tool by pressing trigger inwards, then the tool is energized and starts to operate. (See figure 5) 3) The tool will stop as soon as releasing the trigger of switch. Figure 5 Lock the tool in the “on” position 1) When starting hold the tool firmly with both hands i.e.
5. Maintance and inspection 1) The armature and stator (motor) is the heart of the power tool. Exercise due care to ensure they do not become damaged or affected by oil or water. 2) Inspect the carbon brushes regularly and replace when they are worn up about one third. 3) Regularly inspect all mountings and screws and ensure they are properly tightened. Showed any of the screws be loose, tighten them immediately. Failure to do so may result in serious damage.