Specifications



InstallingDrillorDriverBits
• Removethebattery(5)fr omthedrill.
• Openorclosethekeylesschuck(1)toapointwheretheopeningisslightly
largerthanthedrillordriverbityouintendtouse.
• Insertthedrillordriverbitintothekeyle ss
chuck(1),ensuringtheendof
thedrillordriverbitdoesnottouchthescrewinsidethekeylesschuck(1).
• Tightenthekeylesschuck(1)ontodrillordriverbitasabove(SeeFig.8).

RemovingDrill/DriverBits
• Removethebattery(5)fr omthedrill.
• Loosen
thekeylesschuck(1)asdescribedpreviously.
• Removethedrillordriverbitfromthekeylesschuck(1).
Note:Donothandledrillbitswithoutglovesasdrillbitsandotheraccessoriesaresharporcanbehotafteruse,
thiscancausepersonalinjury.

GeneralHintsforDrilling
inallMaterials
• Alwaysusesharpdrillbits.
• Marktheplacewhereyouwouldliketheholetobedrilled.
• Commencewithaslowspeedtostartthehole(seesection"SpeedControl"fordirectionsonhowtodo
this).
• Reduceyourpressureonthedrillwhen
thedrillbitisabouttobreakthroughthematerial.

MetalDrilling
• Supportthinmaterialwithapieceofscrapwood.
• Useacenterpunchtomar kthepositionofthehole.
• Ifdrillingalargehole,useasmallsizedrillbitfirsttoestablisha
pilotholethenusetherequiredlargesize
drillbit.
• UseonlyHSS(highspeedsteel)drillbitsorthoserecommendedformetaluse.
• Whendrillingintoironorsteel,useacoolinglubricantsuchasthinoil.Withaluminum,useturpentineor
paraffin.Withbrass,copperandcast
iron,usenolubricantbutwithdrawthedrillregularlytoassist
cooling.

WoodDrilling
• Marktheplacewhereyouwanttodrillwithapunchoranail.
• Toavoidsplinteringonbreakthrough,eitherclampapieceofscrapwoodtothebackofyourworkpieceor
continue
theholefromthebackofthewoodwhenthedrillbitfirstbreaksthrough.

LEDLight
• Thedrillhas1LEDLight(8)builtintotheunit.TheLEDlightislocatedabovethevariablespeedswitch.
• TheLEDlight(8)turnsonautomaticallywhenyoudepressthe
variablespeedswitch(7).
• TheLEDlightilluminatesdarkareasintightcornerstoassistwithdrillingandscrewdriving.Thishelps
achieveamoreaccurateresultinyourworkpiece.




