User's Manual

ATD-3060

11 PC LOCKING WHEEL NUT REMOVER

INSTRUCTION MANUAL

1. Position socket over lock to be removed

2. Insert socket installing driver into center broach and drive socket onto lock by firmly hitting driver with large hammer.

3. Remove socket with 1/2” extended driver or breaker bar

NOTE: SOCKET INSTALLING DRIVER MUST BE USED TO SET THE SOCKET ON THE NUT. HAMMERING THE ENDS OF THE SOCKET

WILL DAMAGE THE TOOL AND VOID THE WARRANTY.

NOTE: Use EXTRACTOR PUNCH to knock the lock out of the socket.

1. Position socket over lock to be removed

2. Insert socket installing driver into center

broach and drive socket onto lock by firmly hitting driver with large hammer.

3. Remove socket with 1/2” extended driver or breaker bar

NOTE: FOR AFTERMARKET STYLE WHEEL LOCKS, IT MAY BE NECESSARY TO USE A 1/2" DRIVE IMPACT GUN WITH EXTENSION TO

SPIN THE SOCKET OVER THE LUGNUT TO BE REMOVED FOR ABOUT 5 SECONDS AT HIGH SPEED IN A COUNTER-CLOCKWISE

DIRECTION. REMOVE THE IMPACT GUN AND RESET THE SOCKET WITH THE DRIVER. REPLACE THE IMPACT GUN AND, AT HIGH

SPEED, SPIN THE LOCK OFF IN A COUNT

ER-CLOCKWISE DIRECTION.

NOTE: SOCKET INSTALLING DRIVER MUST BE USED TO SET THE SOCKET ON THE NUT. HAMMERING THE ENDS OF THE SOCKET

WILL DAMAGE THE TOOL AND VOID THE WARRANTY.

NOTE: Use EXTRACTOR PUNCH to knock the lock out of the socket.

PAGE 1
ATD-3060 11 PC LOCKING WHEEL NUT REMOVER INSTRUCTION MANUAL 1. Position socket over lock to be removed 2. Insert socket installing driver into center broach and drive socket onto lock by firmly hitting driver with large hammer. 3. Remove socket with 1/2” extended driver or breaker bar NOTE: SOCKET INSTALLING DRIVER MUST BE USED TO SET THE SOCKET ON THE NUT. HAMMERING THE ENDS OF THE SOCKET WILL DAMAGE THE TOOL AND VOID THE WARRANTY. NOTE: Use EXTRACTOR PUNCH to knock the lock out of the socket. 1.
PAGE 2
1. To remove damaged or rounded lugnut/lugbolt, simply place the twist socket lugnut remover over the fastener and turn with a 1/2" drive impact, breaker bar or other related tool. NOTE: Use EXTRACTOR PUNCH or Vice Grips to remove the damaged fastener out of the twist socket lugnut remover. 1. Tap lock over hubcap lock 2. Remove lock with 3/4" socket NOTE: DO NOT USE IMPACT GUN WITH THIS TOOL 1. To remove GM Spline style hubcap locks, use side (b). 2.
PAGE 3
ITEM# 1 2 3 4 5 6 7 8 9 10 11 ORDERING PART# PRT3060-01 PRT3060-02 PRT3060-03 PRT3060-04 PRT3060-05 PRT3060-06 PRT3060-07 PRT3060-08 PRT3060-09 PRT3060-10 PRT3060-11 PART DESCRIPTION 13/16" DEEP INTERNAL REVERSE THREAD 1" DEEP INTERNAL REVERSE THREAD SOCKET EXTRACTOR PUNCH SOCKET INSTALLING DRIVE GM SPLINE HUBCAP LOCK REMOVER FORD/CHRYSLER CYLINDER GM HUBCAP LOCK REMOVER LARGE CHRYSLER CYLINDER SMALL DUAL SIDED SOCKET GM DUAL SOCKET DUAL SIDED TWIST LUGNUT/LUGBOLT