ATD-7343 3 TON LOW PROFILE ALUMINUM FLOOR JACK USER’S MANUAL Specifications: Capacity: Min Height: Max Height: Length: 3 Tons 3.75" 18.1" 26.4" Chassis Width: 13" Saddle Diameter: 4.52" Net Weight: 55 lbs This hydraulic jack conforms to all “ANSI / ASME” safety standards.
SAFETY WARNING AND PRECAUTIONS General Safety Warnings: WARNING: The instructions and warnings contained in this manual should be read and understood before using or operating this tool. Do not allow anyone to use or operate this tool until they have read this manual and have developed a thorough understanding of how this tool works. Failure to observe any of the following instructions could result in severe personal injury to tool user and bystanders, or cause damage to the tool and property.
WARNING: Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine and apply the brake. Chock each unlifted tire in BOTH directions as shown below. WARNING: Position the jack under the manufacturer's recommended lifting point for the vehicle. Off centered loads can slip and accidents may result. WARNING: During raising and lowering of the load, precautions should be taken to avoid movement of the vehicle.
Support the vehicle with appropriate jack stands. Lift the vehicle to remove the jack stands, ensuring that there are no persons or obstructions under the vehicle. Turn the handle counter‐clockwise. MAINTENANCE: Important: Both the maintenance and repair of the jack may only be performed by qualified persons, who have sufficient knowledge of the hydraulic system used in these jacks Regularly lubricate the moving parts in the wheels, arms, handle and pump roller pin.
TROUBLESHOOTING: CAUTION: To prevent personal injury, all inspection, maintenance, and repair procedures must be performed when the jack is free of load. Trouble Jack Does Not Lift Jack lifts only partially Jack advances slowly Jack lifts load, but doesn't hold Jack leaks hydraulic fluid Jack will not retract Cause Solution 1. Release valve is open 1. Verify the release valve is closed. Release valve may need cleaning 2. Low/no hydraulic fluid in reservoir 2.
ATD-7343 ITEM# 1 2 3 4 5 6 7 8 9 10 ORDERING PART# PRT7343-01 PRT7343-02 PRT7343-03 PRT7343-04 PRT7343-05 PRT7343-06 PRT7343-07 PRT7343-08 PRT7343-09 PRT7343-10 PART DESCRIPTION P01 - SADDLE PAD P02 - SADDLE SCREW P03 - SADDLE P04 - SADDLE BASE P05 - LIFT ARM ASSEMBLY P06 - RADIUS ROD P07 - FRONT WHEEL P08 - CARRYING PLATE P09 - SIDE PLATE P10 - REAR CASTER ASSEMBLY ITEM# 11 12 13 14 15 14,15 16 17 18 N/S ORDERING PART# PRT7343-11 PRT7343-12 PRT7343-13 PRT7343-14 PRT7343-15 PRT7343-HD PRT7343-16 PRT734
WARRANTY 1 YEAR REPLACEMENT WARRANTY THIS WARRANTY AND CONFIRMED RECEIPT (S) SHOULD BE RETAINED BY THE CUSTOMER AT ALL TIMES The warranty is only made available by returning the product to the point of sale. PURCHASED FROM:________________________________________________ DATE PURCHASED: ________________________________________________ INVOICE/RECIEPT NUMBER:_________________________________________ Your ATD‐7343 is warranted for a period of 12 months from the original date of.