Heavy Duty Engine Cranes Operating Instructions & Parts Manual Capacity 2 Ton 2 Ton Model Number Atd-7484 Atd-7485 (Foldable Legs) Model Atd-7484 Model Atd-7485 Atd Tools Inc.
Save these instructions. For your safety, read and understand the information contained within. The owner and operator shall have an understanding of this product and safe operating procedures before attempting to use this product. Instructions and Safety information shall be conveyed in the operators native language before use of this product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with the use and misuse of the product.
BEFORE USE ASSEMBLY For Model Atd-7484: (See Figure 1) 1. Attach casters (#15) to rear extension legs (#24) with M8x20 bolts, washers and nuts (#29, 33 & 34). 2. Slide front extension legs (#14) and rear extension legs (#24) into base frame (#11), secure with M12x25 bolts (#13) in frame, tighten bolts. Note: Do not tighten any bolts unless told to. Never 1. Inspect crane before each use. Do not use if bent, broken or cracked components are noted. Ensure that casters/wheels and boom move freely.
ASSEMBLY (continued) For Model Atd-7485 (see Figure 2): 1. Attach caster assembly (# 23) to base frame (# 24) using M8x16 bolts, washers and nuts (# 14, 21 & 22). 2. Install 3.5 " middle wheels (# 33) to base frame (# 24) using M8x60 bolts, rod cover, washers and nuts (# 31, 32, 22 & 21). 3. Attach two front legs (# 27 & 35) to base frame (# 24) using M16x85 bolts, washers and nuts (# 43 & 9). Then secure the legs with stop bar and pin (#25 & 34) to the front hole of the legs. 4.
OPERATION MAINTENANCE Important: Use only a good grade hydraulic jack oil. We recommend Mobil DTE 13M or equivalent. Avoid mixing different types of fluid and NEVER use brake fluid, turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause premature failure of the jack and the potential for sudden and immediate loss of load. 1. Load capacity should be coordinated with boom extension and legs extension.
TROUBLESHOOTING Symptom Possible Causes Corrective Action Crane will not lift load • Release valve not tightly closed • Overload condition • Ensure release valve tightly closed • Remedy overload condition Crane will lift, but not maintain pressure • Release valve not tightly closed • Overload condition • Hydraulic unit malfunction • Ensure release valve tightly closed • Remedy overload condition • Contact Atd Tools Tech.
REPLACEMENT PARTS Available Parts: Please refer to the Parts drawing when ordering parts. Not all components of the jack are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence. When ordering parts, give Model number, serial number and description below. Call or write for current pricing: Atd Tools Inc. 160 Enterprise Drive, Wentzville, MO 63385. Tel:(838)272-9050 Fax:(636)272-9044 Model Atd-7484 Ref. 1 2 3 4 5 6 7 8 9 — — — Part No.
Model Atd-7485 Ref. 01 02 03 04 05 06 07 08 09 10 11 12 13 — — Parts No.
