User's Manual

WARNING:Groundedtoolsmustbepluggedinto anoutletproperlyinstalledandgroundedinaccordancewith
allcodesandordinances.Thistoolisequippedwitha3‐prongpluganda3‐wiregroundin g system.Neverremovethe
groundingprongormodifythepluginanyway.Donotuseanyadapterplugs.Checkwithaqualifiedelectricianifyou
areindoubtastowhethertheoutletisproperlygrounded.

NOTE:Doubleinsulatedtoolsareequippedwithapolarizedplug(onebladeiswiderthantheother).Thisplug
willfitinapolarizedoutletonlyoneway.Iftheplugdoesnotfitfullyintheoutlet,reversetheplug.Ifitstilldoesn’tfit,
contactaqualifiedelectricianto
installapolarizedoutlet.Donotchangethepluginanyway .

WARNING:Toreducetheriskofelectricshock,DONOTuseindampconditions,onwetsurfaces,orexposeto
rain.Donotpluginthistooloroperateitwithwethandsorwhilestandinginwater.

WARNING:Neverusethecordforcarrying,pullingorunpluggingthepowertool.Graspplugandpullto
disconnectfromoutlet.Keepcordawayfromheat,oil,sharpedgesormovingparts.Replacedamagedcords
immediately.

WARNING:Donotcarrythepowertoolwithyourfingerontheswitch.Ensuretheswitchisintheoffposition
beforepluggingthetoolintothepoweroutlet.Intheeventofapowerfailurewhileatoolisbeingused,turntheswitch
offtopreventsurprisestartingwhenthe
powerisrestored.

WARNING:Alwaysremovethepowercordfromtheelectricoutletwhenmakingadjustments,changingparts,
cleaningorworkingonthetool.

WARNING:Careshouldbetakentoarrangethecordsoitwillnotbesteppedon,trippe dover,orotherwise
subjectedtodamageorstress.

WARNING:Neverattempttopluginoroperateequipmentwithdefectiveordamagedwires,powercordor
powercordplug.Haveanydefectiveordamagedpartsreplacedimmediatelybyqualifi edpersonnel.

WARNING:Avoidbodycontactwithelectricallygroundedsurfaces.Thereisanincreasedriskofelectricshockif
yourbodyisgrounded.

WARNING:IftheworkareaisnotequippedwithapermanentlyinstalledGroundFaultCircuitInterrupteroutlet
(GFCI),useaplug‐inGFCIbetweenthepowertoolorextensioncordandthepowerreceptacle.

WARNING:Ifanextensioncordisnecessary,useonly‘Listed’extensioncords.Ifusedoutdoors,theymustbe
marked“ForOutdoorUse”.Thosecordshavinga3‐pronggroundingtypeplugsandmatingreceptaclesaretobeused
withgroundedtools.

WARNING:Useofimpropersizeorgaugeofextensioncordmaycauseunsafeorinefficientoperationofyour
tool,orcausedamagetoyourtool.Besureyourextensioncordisratedtoallowsufficientcurrentflowtothemotor.If
indoubt,alwaysusealargergaugecord.Besureto
checkthevoltagerequirementsofthetooltoyourincomingpower
source.